Skip to content
Kempenfelt Bay Garage Door Co.Request a visit
Open 24/7(249) 315-4741Call now
Person kneeling inside a garage reaching up along the vertical track of a white paneled door, with a toolbox and drill nearby. — Garage Door Cable Replacement, Barrie

Emergency Springs · Barrie

Garage Door Cable Replacement

Your older door has springs along the tracks, and one cable has slipped off its pulley and dangles slack. The door lifts crooked and needs a shoulder to close, when it used to glide.

Call now · open 24/7(249) 315-4741

Request a visit

Right now

Before the door is looked at

Call (249) 315-4741, open 24/7.

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

In plain words

Winter is hard on the bottom of a garage door. Slush and road salt run off the car and pool exactly where the cables loop onto the bottom brackets, and wire rope that is wet and salted for four months a year rusts from the inside out. Snow packed under the door can also stop it short, letting the cables go slack and slip their drums. Cable replacement puts fresh galvanized cable on both sides, cleans or renews corroded brackets and resets the balance, and the technician can show you how a clear threshold and a light coat of lubricant carry the new set through many more winters.

Sound familiar?

Your older door has springs along the tracks, and one cable has slipped off its pulley and dangles slack. The door lifts crooked and needs a shoulder to close, when it used to glide.

How the visit goes

Garage Door Cable Replacement · Barrie

How the visit goes

Technician at a blue ladder working under a black and white opener, with a red pull cord hanging beside it.
  1. 1

    Track, rollers and the door itself

    The last part of the first look follows the door's path. The technician checks that the vertical tracks are plumb and evenly spaced from the door, that the curve into the horizontal run is smooth, and that the track brackets are tight to the jamb. Rollers are checked for cracked wheels and bent stems, hinges for splits, and the bottom section for a dent or bow from a vehicle. Any of these can rub a cable or hold one corner back, and each is easier to correct while the counterbalance is unloaded. If the door is off its track as well, that is set straight as part of the same work.

  2. 2

    Winding the springs back on

    The torsion springs are wound back up with the winding bars, a quarter turn at a time, to the number of turns the door height calls for, which is roughly one full turn for each foot of door plus a small allowance the technician judges from the balance test. The cone set screws are tightened to the shaft, the bars are removed, and the clamps come off. The cables are watched as the door is raised to make sure each wraps onto its drum in a single neat layer with no overlap and pays out cleanly on the way down. A quarter turn added or removed fine-tunes the balance.

  3. 3

    Checking the balance yourself, safely

    You can confirm the door is still balanced any time without touching a spring or cable. With the door closed, pull the opener's release cord so the trolley disconnects, then lift the door by its handle or a safe gripping point to about waist height and let go gently. A balanced door should not lift or fall far on its own; a little slow drift is normal, and what calls for a technician is rapid movement, a heavy feel, binding in the track, or a result outside the manufacturer's balance instructions, not drift alone. Reconnect the opener as the manual describes, usually by running it once. Doing this each season catches wear early and keeps the opener working lightly.

In the van

  • Galvanized aircraft-type lift cables
  • Drum set screws
  • Winding bars
  • Bottom brackets with cable pin
  • Clevis pins and cotter pins

What affects the quote

  1. 1

    One cable or the pair

    Cables are normally renewed together, and the quote reflects two cables and the work of setting both sides level. Where one side was recently replaced, that is discussed on site.

  2. 2

    Drums that need replacing

    Worn grooves, a cracked slot or a drum that has spun on the shaft mean a new pair of drums, which adds parts and a little time to the same visit.

  3. 3

    Impact damage to track or sections

    A bumper strike often bends the track, a hinge or the bottom section as well as displacing the cable. Straightening or replacing those parts is quoted as separate work.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 315-4741

Garage Door Cable Replacement: questions

Advice · (249) 315-4741

Why did the cable come off the drum?

A cable leaves its drum when it goes slack for a moment while the drum keeps turning. The usual reasons are the door closing onto an object or a ridge of ice so the bottom stops early, a spring that has lost tension or broken, or a drum whose set screws let it slip on the shaft. The technician finds which of these happened and corrects it so the new cable stays seated.

Can I use the door as soon as the work is finished?

Yes. The visit ends with the door balanced by hand, run through full cycles and the opener reconnected and tested, so it is ready for normal use the moment the technician packs up. There is no settling period for cables. It is a good idea to watch the first few openings yourself to get a sense of how a level, balanced door sounds, so you notice any change later.

Why should the bottom brackets never be loosened by hand?

The bottom bracket is where the cable attaches, so whenever the springs are wound it carries a share of the door's weight as tension. Loosening it while the counterbalance is loaded releases that tension all at once. Many manufacturers now fit tamper-resistant fasteners for this reason. The technician unloads the springs first, after which the bracket is just a piece of hardware to unbolt and replace.

Garage Door Cable Replacement near you

Simcoe, Ontario

Barrie information

Town
Barrie, Simcoe, Ontario
In business
22 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

29%

Newer homes. About 29% of homes in Barrie were built in 1980 or earlier, according to the 2021 Census.

Many newer homes have a keypad by the door, several remotes and an app that reports whether the door is open. We keep all of these talking to the opener, clear codes from devices that have gone missing and set up new ones so the whole household is covered.

58%

A mix of homes. Single-detached houses make up about 58% of homes in Barrie (2021 Census).

Mixed housing brings mixed garage use: workshops and storage in the detached homes, everyday parking and a tight squeeze in the attached ones. Sealed rollers and protected sensors suit the busy workshop door; a quiet opener and a well-balanced door suit the townhouse.

Source: Statistics Canada, 2021 Census of Population

Open Barrie in Google Maps

Open 24/7

Request a visit

Your older door has springs along the tracks, and one cable has slipped off its pulley and dangles slack.

Call now · open 24/7(249) 315-4741
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 22 years in business