Skip to content
Kempenfelt Bay Garage Door Co.Request a visit
Open 24/7(249) 315-4741Call now
Two detached black sensors with recessed lenses and coiled wires lie in a tray beside a mounting bracket. — Photo-Eye Sensor Alignment or Replacement, Barrie

Book soon Openers · Barrie

Photo-Eye Sensor Alignment or Replacement

Since shelving went up along the garage wall, the door will not close and both sensor lights are dead. A screw or staple may have gone through the thin wire that runs from the opener to the sensors.

Call now · open 24/7(249) 315-4741

Request a visit

Right now

Before the door is looked at

Call (249) 315-4741, open 24/7.

  1. Never bypass, tape over or relocate the sensors to make a door close; a door that reverses is reporting something worth fixing.

In plain words

The sensors are only as good as the thin two-conductor wire that links them to the opener. It runs from the low-voltage terminals on the head unit along the ceiling and down each wall to the floor, stapled as it goes, and it is easily pierced, cut during renovations, chewed, or pulled loose at the terminals. When both sensor lights are dark, or the opener's code says the circuit is open or reversed, the technician tests the run end to end, repairs the damaged section or replaces the whole run, checks polarity at the terminals, and clips the new wire clear of the track.

Sound familiar?

Someone backed the car in a little too far, a bin or a bicycle brushed the track, and since then the door starts to close and comes back up. One sensor now sits at a slightly different angle from the other.

How the visit goes

Photo-Eye Sensor Alignment or Replacement · Barrie

How the visit goes

Technician at a blue ladder working under a black and white opener, with a red pull cord hanging beside it.
  1. 1

    Clearing and walking the beam

    Before anything is adjusted, the technician clears the strip of floor between the two sensors and looks along the beam line at sensor height. Things that break a beam are rarely dramatic: the corner of a recycling bin, a hose left coiled by the wall, a bag of salt, leaves blown in under the door, a cobweb bridging a lens, a new weatherstrip or track shoe that sits a little proud. Snow and ice piled inside the door in winter count too. With the path clean, the door is tried again, because a fair share of sensor calls end right here, with a lesson about where things can and cannot sit.

  2. 2

    Dealing with the sun

    A receiver that looks into the low sun is fixed by geometry. The simplest cure is to swap the two sensors side to side so the receiver looks away from the doorway light and the sending eye, which is not affected, takes the sunny position. Where the layout rules that out, a small hood or shade is fitted over the receiving lens, deep enough to shield it without narrowing the beam path. The wiring is extended or re-routed as needed and both lights are checked at the time of day the fault used to appear, or with a strong light aimed at the lens to stand in for the sun.

  3. 3

    A door that closes from the driveway again

    The change you notice first is the ordinary one: you press the remote from the car, the door goes all the way down, and nobody has to stand in the garage holding a button. Behind that is a beam that is once more crossing the doorway at the right height, a pair of sensors that agree with each other, and an opener that is no longer flashing a warning every time you ask it to close. The door still stops and returns to open whenever the beam is broken, which is exactly what it should do, and now it does that only when something is genuinely in the way.

In the van

  • Receiving-eye sun shade
  • Wing nuts and carriage bolts
  • Concrete anchors
  • Track-mount sensor brackets
  • Matched photo-eye sensor pair

What affects the quote

  1. 1

    Access to the doorway and the head unit

    A clear strip along the floor and a reachable head unit make for a direct job. Shelving, vehicles or stored goods that must be moved to reach the sensors, wire or terminals add time.

  2. 2

    Length and route of the wire run

    A damaged section near a sensor is a short repair. A fresh run from the motor to both sides of the doorway takes longer, more so where the wire is buried in a finished ceiling.

  3. 3

    Number of doors

    Each opener has its own sensor pair and wire run, so a double garage with two doors is two sets of checks, two possible pairs and two rounds of testing, quoted per door.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 315-4741

Photo-Eye Sensor Alignment or Replacement: questions

Advice · (249) 315-4741

My opener has no sensors at all. Can they be added?

If the opener predates the entrapment-protection standard, which operators have had to meet since the mid-1990s, its board has no sensor circuit and a pair cannot simply be wired in. The positive news is that a modern operator brings the whole package: matched sensors, force reversal and a monitored circuit. The technician confirms the model first, because some units do have the terminals and simply had their sensors removed.

Do sensors wear out with age?

They do, slowly. The infrared emitter and the receiver dim over many years, lenses craze or cloud from sun and salt, housings crack, and water finds its way in at floor level. A pair that needs re-aligning more and more often, or whose light drifts between steady and flickering with nothing touched, is usually ageing. Because pairs are matched to the opener, an older opener is worth identifying early so the right replacement is on hand.

Is it all right to keep using the door until the visit?

Use the door in a way that keeps you in control. If the opener closes only while the wall button is held, do that only while you can see the whole doorway and nobody is near it. Otherwise close the door first if you can, then move it by hand with the manual release, and get help if it feels heavy or binds. Keep children and pets clear during any test. A door that reverses is being cautious on your behalf.

Photo-Eye Sensor Alignment or Replacement near you

Simcoe, Ontario

Barrie information

Town
Barrie, Simcoe, Ontario
In business
22 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

29%

Newer homes. About 29% of homes in Barrie were built in 1980 or earlier, according to the 2021 Census.

Many newer homes have a keypad by the door, several remotes and an app that reports whether the door is open. We keep all of these talking to the opener, clear codes from devices that have gone missing and set up new ones so the whole household is covered.

58%

A mix of homes. Single-detached houses make up about 58% of homes in Barrie (2021 Census).

Mixed housing brings mixed garage use: workshops and storage in the detached homes, everyday parking and a tight squeeze in the attached ones. Sealed rollers and protected sensors suit the busy workshop door; a quiet opener and a well-balanced door suit the townhouse.

Source: Statistics Canada, 2021 Census of Population

Open Barrie in Google Maps

Open 24/7

Request a visit

Since shelving went up along the garage wall, the door will not close and both sensor lights are dead.

Call now · open 24/7(249) 315-4741
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 22 years in business