Skip to content
Kempenfelt Bay Garage Door Co.Request a visit
Open 24/7(249) 315-4741Call now
Person in a jacket facing a closed white sectional door, with coiled springs and steel tubes on a wooden bench. — Extension Spring Replacement, Minet's Point

Emergency Springs · Minet's Point

Extension Spring Replacement in Minet's Point

The door climbs with the left corner ahead of the right, then twists as it turns into the ceiling track. Looking up, the spring on the right side is stretched longer than its partner, with daylight showing between the coils.

Call now · open 24/7(249) 315-4741

Request a visit

Right now

Before the door is looked at

Call (249) 315-4741, open 24/7.

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

  3. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released. Use the release, the outside key release, or a technician.

In plain words

What you have afterwards is a door that behaves like a much lighter object. Both corners leave the floor together, the door holds still when you stop it at waist height, and it settles onto the floor instead of slamming. The opener runs quietly, because it is guiding a balanced door rather than hauling a heavy one, and its safety reversing works as designed. Both springs are new, both carry a containment cable, the pulleys turn freely and both S-hooks sit in the same hole. You also get the spring rating and door weight written down, so the next set can be ordered without measuring everything again.

Sound familiar?

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows. The motor is the same one it always was; something in the springs has stopped doing its share.

How the visit goes

Extension Spring Replacement · Minet's Point

How the visit goes

Technician at a blue ladder working under a black and white opener, with a red pull cord hanging beside it. — Minet's Point
  1. 1

    The rest of the door, and why the spring went

    A spring rarely fails on its own, so the first look ends with the door it was lifting. The technician checks the rollers for cracked wheels and bent stems, the hinges for splits, the track for a bend or a bracket pulled off the jamb, and the bottom section for a dent that catches. The opener's force setting is noted, since an opener turned up to compensate for tired springs will overpower the new ones. And the history matters: a door recently fitted with insulation panels or windows weighs more than the springs were chosen for, and a door that has been closed onto snow or a bin has had its cables jolted.

  2. 2

    Balancing the door by hand

    Balance is judged with the opener still disconnected. The technician lowers the door to the floor, then lifts it: it should rise with modest effort, stay put when let go at about waist height, sit steady when fully open, and come down under control rather than dropping. If it sinks, both springs need a little more stretch and each S-hook is moved one hole to take up cable; if it climbs on its own, one hole the other way. Adjustments are always made in pairs, with the door open and clamped again each time, so the two springs stay equal. Two or three rounds usually settle it.

  3. 3

    Containment cables, and leaving them be

    Your door now has a cable running through the middle of each spring, anchored at the back hanger and at the front of the track. It carries no meaningful load while the springs work, though a trace of slack as the door cycles is normal. Its job begins only if a spring ever breaks, when it holds the pieces on the cable instead of letting them fly. It should not be removed, used to hang anything, or tied back to the wall. If it ever looks badly slack, frayed or pulled from its anchor, call to have it corrected promptly rather than waiting for a routine visit. A home inspector looks for this cable when a house is sold.

In the van

  • Replacement rollers and hinges
  • Rear spring hangers and angle iron
  • S-hooks and adjusting clips
  • Pulleys (sheaves) and forks
  • Lag screws and hanger bolts

What affects the quote

  1. 1

    Weight added since the door went in

    Insulation panels, windows or a wood overlay fitted after the original springs mean a heavier rating than the old pair. The door is weighed and the quote reflects the door as it is now.

  2. 2

    How the door is sitting

    A door resting closed with one spring gone is straightforward. A door stuck partway, twisted in its tracks or with a cable wrapped around a pulley has to be supported and straightened first.

  3. 3

    Rollers, hinges and bottom brackets found worn

    Cracked roller wheels, split hinges or a bottom bracket rusted at the cable pin are pointed out during the inspection and offered as optional items, since the door is already open and secured.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 315-4741

Extension Spring Replacement: questions

Advice · (249) 315-4741

What does the paint colour on the end of the spring mean?

Manufacturers dab a colour on the end coil to indicate the spring's weight rating, which is a handy starting point. It is not the final word: a faded or repainted end coil tells you little, and the pair on an older door may have been a near match rather than the right one. The technician treats the colour as a hint and confirms the rating from the door's measured weight and the spring's own dimensions.

How do you know which springs my door needs?

By weight. Extension springs are rated for the weight they lift, so the technician releases the opener and weighs the door on a scale, then matches that figure and the door's height to a spring rating and stretch length. The old springs are measured as a check on wire size, coil diameter and length. Where the two disagree, the scale decides, since doors gain weight from added insulation or panels.

Can I use the door as soon as the work is done?

Yes. The last steps of the visit are the balance test by hand, several full cycles under power and the opener's reversal checks, so the door is ready for normal use when the technician leaves. New springs need no settling period. It is worth running it yourself once or twice while the technician is still there, so you know what a properly balanced door sounds and feels like from now on.

Extension Spring Replacement near you

Simcoe, Ontario

Minet's Point information

Town
Minet's Point, Simcoe, Ontario
In business
22 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

29%

Newer homes. About 29% of homes in Barrie were built in 1980 or earlier, according to the 2021 Census.

A newer door still under its first set of springs is a good candidate for preventive work: lubricating the torsion spring, checking the cable ends at the drums and confirming balance before the spring reaches its cycle limit, so the replacement is planned rather than forced by a broken spring.

58%

A mix of homes. Single-detached houses make up about 58% of homes in Barrie (2021 Census).

A neighbourhood with a mix of detached houses and townhouses or condos means a technician moves between a wide family double door and a narrow single in a row within the same afternoon. The van carries hardware for both, and each visit is planned for that door.

Source: Statistics Canada, 2021 Census of Population

Open Minet's Point in Google Maps

Open 24/7

Request a visit

The door climbs with the left corner ahead of the right, then twists as it turns into the ceiling track.

Call now · open 24/7(249) 315-4741
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 22 years in business